tyre pressure RENAULT KANGOO 1997 KC / 1.G Foult Finding - Injection Workshop Manual

B76531.0
ELECTRONICALLY CONTROLLED HYDRAULIC SYSTEM
Fault finding - Fault chart 38
ABS BOSCH
5.3
AFTER REPAIR Carry out a road test, then a check with the XR25 kit.
yes
PULLINGFault chart 5
Only consult this section after a complete check with the XR25 kit.NOTES
Lift the vehicle so the wheels can be turned
and check for :
- a possible incorrect connection in the
speed sensors,
- a possible incorrect connection of the
hydraulic assembly piping.
For these two checks, consult and apply the
methods defined in Fault Chart 4.Check the
condition of the ABS targets and that they
conform. Also check the sensor/ target air
gap by rotating each wheel.
If the fault persists, replace the hydraulic
assembly.
If the pedal travel is relatively long, bleed
the brake circuit.
If it is normal, check the tyre pressure, the
front axle assembly
or possibly for leaks in the circuit.
no
Remove the 10A ABS fuse on the passenger
compartment connection unit and carry out
a road test with the ABS non-operational.
Does the fault persist under these
conditions?
38-25

B76531.0
ELECTRONICALLY CONTROLLED HYDRAULIC SYSTEM
Fault finding - Fault chart 38
ABS BOSCH
5.3
AFTER REPAIR Carry out a road test, then a check with the XR25 kit.
yes
WANDERINGFault chart 6
Remove the 10A ABS fuse in the passenger
compartment connection unit and carry out
a road test with ABS non-operational.
Does the fault persist under these
conditions?
Only consult this section after a complete check with the XR25 kit.NOTES
Normal behaviour linked to system
operation in the regulation phase
essentially because of asymmetrical grip or
poor road surface.
Handling fault not linked to ABS system.
Check the condition and conformity of
brake linings, check tyre pressures, front
axle assembly, ...
no
38-26